Back cover IP20
A5E34382870-AH, 04/2019
15
Current information about which devices can also be equipped with the back cover IP20, is available on the Internet
http://support.automation.siemens.com/WW/view/en/92558323/133200
Devices that can be ordered with mounted back cover IP20
The back cover IP20 is mounted on the device. Applies to:
●
IPC277D 15" and IPC277D 19"
●
IPC477D 15", IPC477D 19" and IPC477D 22"
●
IPC477E 15" ST, IPC477E 19" ST and IPC477E 22" ST
Note
Observe the following points:
•
You are also going to need this document whenever the system is recommissioned.
Keep all supplied and supplementary documentation for the entire service life of the device.
•
Make sure that the persons who require these documents have access to them.
•
Submit all of these documents to a future owner of the device.
Structure of the back cover IP20
Rear view and side view
The figures below show the back cover IP20 for a 19" device as an example.
①
Curvature only for back covers for 19" and 22" devices
After mounting the curvatures cover the screws remaining in the device.
②
Cover for the memory card slots for Comfort Panel and Industrial Thin Client
③
Locking screw
④
Interface cover
⑤
Locking screw
Scope of delivery
●
1 × back cover IP20
The back cover IP20 is designed to fit the devices in the various display sizes and is equipped with an interface adapter
suitable for the device family.
●
1 × Product Information "Back cover IP20"
●
1 × accessory kit
The accessory kit contains screws for mounting.
The accessory kit contains a label for interface labeling. This label is required only for SIMATIC Industrial Thin Clients.
●
1 × packaging
