Back cover IP20
A5E34382870-AH, 04/2019
19
Mounting the device
The mounting of the device with mounted back cover IP20 on a machine or plant is the responsibility of the plant constructor.
Note
Observe the following points:
•
The fastening point for the device with back cover IP20 must be designed for four times the weight of the device.
Note the information about the VESA MIS-D 100 classification of the VESA standard.
•
The ventilation slots on the back cover IP20 must not be covered after mounting.
Opening and closing of the cover for memory card slots
The section applies to the versions of the Comfort Panels according to section "Validity (Page 14)". The following section
describes the opening and closing of the cover for the memory card slots.
The data listed in the section "Technical Specifications" of the associated section "Validity (Page 14)" are only guaranteed if
the cover is closed.
Requirement
●
Back cover IP20 is mounted
●
T10 screwdriver
Procedure
The following procedure shows the back cover IP20 for the HMI device TP2200 Comfort and also applies to all back covers
IP20 that have a cover for memory card slots.
Opening
1.
Remove the screw
②
.
2.
Grab the rod
③
and move the cover
①
away from the device.
3.
Put down the cover.
The slot for the storage medium is accessible.
Requirement and procedure for inserting and removing the storage medium are described in the document of the relevant
device.
Close
For closing, follow the steps for opening in reverse order.
