MODULARIS Uro Plus
SPL1-130.840.02
Page 2 of 8
Siemens AG
Rev. 03
04.05
CS PS 24
Medical Solutions
5 - 2
Iso-center with X-Ray
Adjusting the 0° position
5
•
Remove the cover of the shock wave head (refer to chapter 4).
•
Couple the LITHOSTAR MODULARIS to the SIREMOBIL Iso-C as described in the
operating instructions. Do not couple the motor yet.
•
Manually perform the orbital movement (angulation range approx. ± 30°).
•
Set the SIREMOBIL Iso-C to orbital and angulation direction 0°.
•
Couple the motor.
•
Flip up the iso-center phantom.
•
Switch FL ON briefly.
The ball must be in the center of the cross (refer to Fig. 1).
•
If required, adjust the shock wave head as shown in Fig. 3 (A or B):
Fig. 1
Fig. 2
Fig. 3
- A:
Loosen the screws (1/Fig. 2) on both
sides.
- B:
Loosen the screws (3/Fig. 2) on both
sides.
-
Shift it with the screws (2/Fig. 2).
-
Shift it with the screws (4/Fig. 2).
-
Retighten the screws (1/Fig. 2) on
both sides.
-
Retighten the screws (3/Fig. 2) on
both sides.
2
1
1
3
4
ok
acceptable
requires
correction
2/Fig.2
A
B
4/Fig.2
