Operation
4.2 Input Sequence of Data
LDS 6
Operating Instructions, 01/2009, A5E00295894-05
45
Entry into Main Menu for a
1- or 2-Channel System
Whilst in Measuring Mode, the component is shown on the right, with
an arrow ( ). A soft key ① is assigned to this specific component and
it is called by pressing it.
Figure 4-2
Input sequence interacting with LDS 6
Entry into Main Menu for a
3-Channel System
11.13 %
11.28 mg/Nm
3
Ch1
Ch2
Ch3
10.13 %
12.53 mg/Nm
3
15.13 %
5.28 mg/Nm
3
LIM STO CTRL TR CODE
LIM STO CTRL TR CODE
LIM STO CTRL TR CODE
NH
3
NH
3
NH
3
The appearance of the screen menu varies depending on the number of channels and the
number of measured components. For a 3-channel system the soft keys of the measuring
screen are assigned to channels instead of measured components. If the channel has two
components it is necessary to pass a second channel-specific measuring screen before entering
the component-specific main menu.
%vol
H
2
O
NH
3
mg/Nm
3
11.28
11.13
Channel 1
LIM STO CTRL TR CODE
Each channel can be operated independently.
Main Menu
Configuration
Parameters
Measuring Range
Calibration
Analyzer Status
Main Menu Ch1 NH3
The main menu consists of the five items shown in the adjacent screen.
Entering a Submenu
Following the selection of a submenu, you will be asked to enter a password for service
mode ② (exception: submenu "Analyzer status" which requires no password and is thus
freely accessible).
Analyzer status
No code
Calibration
Access level 3
Measuring ranges
Access level 1
Parameters
Access level 1
Configuration
Access level 2
The passwords for levels 1 and 2 are factory-set to the values "111" and "222" respectively.