Siemens HR423214N, Instruction Manual

Page: 16 / 48

16
Detaching the door
1.
Open the oven door fully.
2.
Fold up the two locking levers on the left and right (figure A).
3.
Close the oven door as far as the limit stop. With both hands,
grip the door on the left and right-hand sides. Close the door
a little further and pull it out (figure B).
Attaching the door
Reattach the oven door in the reverse sequence to removal.
1.
When attaching the oven door, ensure that both hinges are
inserted straight into the opening (figure A).
2.
The notch on the hinge must engage on both sides (figure B).
3.
Fold back both locking levers (figure C). Close the oven
door.
:
Risk of injury!
If the oven door falls out accidentally or a hinge snaps shut, do
not reach into the hinge. Call the after
­ sales service.
Removing and installing the door panels
To facilitate cleaning, you can remove the glass panels from the
oven door.
Removal
1.
Detach the oven door and lay it on a cloth with the handle
facing down.
2.
Pull off the cover at the top of the oven door. Press in the
tabs on the left and right using your fingers (fig. A).
3.
Lift the top panel up and pull it out (fig. B).
4.
Lift the panel up and pull it out (fig. C).
Clean the panels with glass cleaner and a soft cloth.
:
Risk of injury!
Scratched glass in the appliance door may develop into a
crack. Do not use a glass scraper, sharp or abrasive cleaning
aids or detergents.
Installation
During installation, make sure that the lettering "top right" is
upside down at the bottom left.
1.
Insert the panel at an angle towards the back (fig. A).
2.
Insert the top panel at an angle towards the back into the
brackets. The smooth surface must face outwards. (fig. B).
3.
Put the cover back in place and press on it.
4.
Attach the oven door.
Do not use the oven again until the panels have been
correctly installed.
% $
% $
&
% $
&
% $