Connecting cables to the HiPath Wireless Outdoor AP
OutdoorAP_ConnectingUp.fm
Connecting an Ethernet cable to the HiPath Wireless Outdoor AP
9034532, October 2009
36
HiPath Wireless Outdoor AP Installation Guide
4.4.1 Removing the power supply adapter
To remove a power supply adapter from HiPath Wireless Outdoor AP:
1. Disconnect the power supply cable from the power supply adapter.
2. Loosen the securing screw of the power supply adapter (Position A in
Figure
21
).
3. Pull the loop (Position B in the
Figure 21
) to remove the connector on the rear
of the power supply adapter from the socket in the housing and remove the
power supply adapter.
4.5 Connecting an Ethernet cable to the HiPath Wireless Outdoor AP
You can connect the Ethernet cable to the HiPath Wireless Outdoor AP’s RJ-45
jack.
To connect an Ethernet cable to the HiPath Wireless Outdoor AP:
1. Insert the connector of the Ethernet cable in the corresponding socket of the
HiPath Wireless Outdoor AP. The location of the socket for RX and TX is
depicted in
Figure 22
.
Figure 22
Position of the Ethernet port with the housing cover removed
2. Secure the Ethernet cable with a strain relief clamp.
Warning
Disconnect power supply cables only when the power to the power supply adapter is turned off!
