14
Cleaning
Clean the door panel with glass cleaner and a soft cloth.
Risk of injury!
Scratched glass in the appliance door may develop into a
crack. Do not use a glass scraper, sharp or abrasive cleaning
aids or detergents.
Fitting the intermediate panel
Note:
During installation, make sure that the lettering "top right"
is upside down at the bottom left.
Insert the intermediate panel towards the back as far as it will
go.
Fitting the door panel
1.
Insert the door panel at an angle towards the back into both
brackets as far as it will go. The smooth surface must face
outwards.
2.
Put the cover back in place and press on it until it clicks in
place.
3.
Refit the appliance door.
Troubleshooting
Malfunctions often have simple explanations. Refer to the table
before calling the after-sales service as you may be able to
remedy the fault yourself.
Malfunction table
If a dish does not turn out as well as you had hoped, refer to
the section
Tested for you in our cooking studio
, where you will
find plenty of cooking tips and notes.
Error messages
If an error message with
§
appears, press the
button. The
message disappears. A time function that has been set is
cleared. If the error message does not disappear, please
contact the after-sales service.
You can take remedial action yourself if the following error
message is displayed.
Risk of electric shock!
Incorrect repairs are dangerous. Repairs may only be carried
out by one of our trained after-sales engineers.
Replacing the oven light bulb
Replace faulty oven light bulbs.
You can obtain replacement light bulbs from customer service
or specialist retailers: E14, 220 - 240 V, 40 W, heat resistant to
300 °C. Only use these oven light bulbs.
Risk of electric shock !
Disconnect the appliance from the power supply. Switch off the
circuit breaker or remove the fuse from the household fuse box.
1.
Place a tea towel in the cold cooking compartment to prevent
damage.
2.
Turn the glass cover anticlockwise and remove it.
3.
Replace the oven light bulb with a bulb of the same type.
4.
Screw on the glass cover again.
5.
Remove the tea towel and switch on the circuit breaker.
Note:
If the glass cover cannot be unscrewed: use rubber
gloves to turn it. You can order a special removal tool through
the after-sales service (order no. 613634)
Glass cover
You must replace a damaged glass cover. Suitable glass
covers may be obtained from the after-sales service. Please
specify the E number and FD number of your appliance.
Problem
Possible cause Remedy/information
The oven does
not work.
The circuit
breaker is
defective.
Look in the fuse box and
check that the circuit
breaker is in working order.
Power cut
Check whether the kitchen
light or other kitchen appli-
ances are working.
and zeros
flash in the dis-
play.
Power cut
Reset the clock.
The oven does
not heat up.
There is dust on
the contacts.
Turn the control knobs back
and forth several times.
Error message Possible cause Remedy/information
§¯³³
A button was
depressed for
too long or is
covered up.
Press all buttons individu-
ally. Check whether any but-
tons are jammed, covered
up or soiled.
