13
Folding down the grill element
You can fold down the grill element to clean the ceiling.
Risk of burns!
The oven must be cold.
1.
Hold the grill element and pull the handle forwards until it
clicks audibly in place (figure A).
2.
Fold the grill element downwards (figure B).
3.
After cleaning, fold the grill element back up and hold it.
4.
Pull the handle downwards until it clicks audibly into place.
Removing and fitting the appliance door
You can remove the appliance door to clean it more
thoroughly.
Risk of injury!
The hinges of the appliance door may snap shut with great
force. Always open the hinge locking lever fully when removing
the appliance door and close it fully after refitting. Do not reach
into the hinge.
Risk of injury!
If the appliance door has only been unhinged on one side, do
not reach into the hinge. The hinge can snap back with great
force. Call the after
ä
sales service.
Removing the appliance door
1.
Open the appliance door fully.
2.
Open the locking levers on the left and right-hand side fully.
The hinges are secured and cannot snap closed.
3.
Close the appliance door until resistance becomes
noticeable (figure A)
4.
With both hands, grip the door on the left and right-hand side,
close the door a little more and pull it out (figure B).
Fitting the appliance door
1.
Insert the hinges in the left and right-hand holders (figure C).
The notch on both hinges must engage.
2.
Open the appliance door fully.
3.
Close the locking levers on the left and right-hand side fully
(figure D).
The appliance door is secured and can no longer be
removed.
4.
Close the appliance door.
Cleaning the door panels
To facilitate cleaning, you can remove the inner door panels
from the appliance door.
Risk of injury!
The components inside the appliance door may have sharp
edges. Take care not to cut yourself. Wear protective gloves.
Risk of injury!
The appliance must not be used again until the door panels
and appliance door have been correctly fitted.
Removing the door panel
Note:
Before removing, make a note of which way round the
door panel is fitted, so that it is not refitted the wrong way
round.
1.
Unhook the appliance door and lay it on a soft, clean surface
with the front side facing downwards (see section: Removing
and installing the appliance door).
2.
Pull off the cover at the top of the appliance door. Press in
the tabs on the left and right using your fingers (fig.A).
3.
Lift the door panel slightly and pull it out (Fig. B).
Removing the intermediate panel
Lift the intermediate panel slightly and pull it out towards you.
#
$
!
"
#
$
"
!
