Configuration
9
Registering Gigaset M105 Data at Gigaset M101 Data
Proceed as follows:
1.
If the M101 is not already in the default status, please ensure that the
M101 is operating as a "Base". Please refer to the configuration program
for the type display and the switch options.
2.
Press and hold down the black button on the Gigaset M101 Data (Base).
After approx. 10 seconds, the LEDs indicate that the system is ready for
registration by flashing in sequence.
3.
Start the
Set Gigaset
program at the PC connected to the Gigaset M105
Data unit.
4.
tab. The type is "Portable part".
5.
Click the
button and enter the PIN.
6.
Click
OK
. The registration procedure starts and the message
"
appears on the screen.
The two devices are automatically synchronised. An entry now appears
in the
Registered bases
list.
7.
Assign a suitable name to the local adapter, e.g. "PC".
8.
Open the
Remote adapter
tab and assign a name to it, e.g. "Gigaset
3075isdn". The registered portable part now also appears in this window.
9.
It may be useful to switch the operating mode from "AT commands (PC)"
to one of the other operating modes. This setting concerns the protocol
on the serial interface, especially the speed adjustment. For more infor-
mation, see
"Setting the operating mode" on page 12
10.
Close the program with
OK
.
In the event of errors or for further information, see
