Configuration
8
Registering Gigaset M105 Data at Gigaset M105 Data
Proceed as follows:
1.
Connect both Gigaset M105 Data units to a PC.
2.
Start the
Set Gigaset
program at both PCs.
3.
4.
Change the type of Gigaset M105 Data at one of the PCs from "Portable
part" to "Base".
5.
Click the
button at both PCs.
At the PC connected to the "Base" type Gigaset M105 Data, a LED flash-
es in sequence to signal that the unit is ready for registration. The config-
uration program is now complete.
Further configuration is now performed exclusively at the PC connected
to the "Portable part" type Gigaset M105 Data. Enter the PIN at this PC.
This is "0000" by default.
6.
Click
OK
. The registration operation starts and the message
appears on the screen.
The two devices are automatically synchronised. There is now an entry
in the
Registered bases
list.
7.
Give the local station a suitable name, e.g. "PC".
8.
Select the
tab and give this also a name, e.g. "Gigaset
3075isdn". The registered portable part also appears in the window here.
9.
It may be useful to switch the operating mode from "AT commands (PC)"
to one of the other operating modes. This setting concerns the protocol
on the serial interface, in particular the speed adjustment. For more infor-
mation, seer
"Setting the operating mode" on page 12
10.
Close the program with
OK
.
In the event of errors or for further information, see
