34
Using several handsets
Gigaset E450 Eco / IM-Nord EN / A31008-M1702-R211-1-SM19 / registr_sett.fm / 18.10.2008
Changing the name of a handset
The names "INT 1", "INT 2" etc. are
assigned automatically at registration.
You can change these names. The name
must be no more than 10 characters. The
changed name is displayed in every hand-
set's list.
u
Open list of handsets. Your
own handset is indicated by
<
.
s
Select handset.
§Edit§
Press the display key.
~
Enter name.
§Save§
Press the display key.
Changing a handset's internal
number
A handset is
automatically
assigned the
lowest unassigned number when it is reg-
istered. If all the numbers have been
assigned, number 6 is overwritten, pro-
vided the handset is in idle status. You can
change the internal number of all regis-
tered handsets (1–6).
u
Open list of handsets. Your
own handset is indicated by
<
.
v
Open menu.
Edit H/Set No.
Select and press
§OK§
. The list of
handsets is displayed.
s
The current number flashes.
Select a handset.
~
Enter the new internal
number(1–6). The handset's
old number is overwritten.
§Save§
Press the display key to save
the input.
a
Press
and
hold
(idle status).
You will hear the error tone (descending
tone sequence) if you assign an internal
number twice.
¤
Repeat the process with an unused
number.
Using a handset as a room
monitor
If the room monitor is activated, a previ-
ously stored destination number is called
as soon as a set noise level is reached. You
can store an internal or external number
in your handset as the destination
number.
The room monitor call to an external
number stops after approx. 90 seconds.
The room monitor call to an internal
number (handset) stops after approx. 3
minutes (depending on the base station).
While the room monitor is activated, all
keys are locked except the end call key.
The handset's speaker is muted.
When the room monitor is activated,
incoming calls to the handset are indi-
cated
without a ringtone
and are only
shown on the screen. The display and key-
pad are not illuminated and advisory
tones are also turned off.
If you accept an incoming call, the room
monitor mode is suspended for the dura-
tion of the call, but the function
remains
activated.
If you switch off the handset, the room
monitor mode is deactivated. You must
reactivate the function after switching on
the handset again.
Caution!
–
You should always check the operation
of the room monitor before use. For
example, test its sensitivity. Check the
connection if you are diverting the room
monitor to an outside number.
– When the function is switched on the hand-
set's operating time is severely reduced. If
necessary, place the handset in the charg-
ing cradle. This ensures that the battery
pack does not run down.
– Ideally the handset should be positioned 1
to 2 metres away from the baby. The micro-
phone must be directed towards the baby.
– The connection to which the room monitor
is diverted must not be blocked by an acti-
vated answering machine.
