Siemens Gigaset E450, User Manual

Page: 43 / 57

42
Appendix
Gigaset E450 Eco / IM-Nord EN / A31008-M1702-R211-1-SM19 / appendix.fm / 18.10.2008
Appendix
Care
¤
Wipe the base station and handset with
a damp cloth (do not use solvent) or an
antistatic cloth.
Never use a dry cloth. This can cause
static.
Contact with liquid
Your handset is splash proof.
If it comes into contact with water, knock
the water out of the microphone opening
and remove any water on the handset
with an absorbent cloth. Your handset is
ready for use.
If your handset comes into contact with a
larger amount of liquid take the following
steps:
1.
Do not switch the handset on under
any circumstances!
2. Remove the battery pack immediately.
3. Remove the headset socket cover.
4. Hold the handset horizontally with the
open battery compartment facing
down.
5. Hold the handset vertically. Tilt the
handset backwards and forwards
slightly, giving it a gentle shake each
time.
6. Dab all parts dry and then leave the
handset for at least 72 hours with the
battery compartment open and the
keypad facing down in a dry, warm
place (not in a microwave, oven or
similar).
When it has fully dried out, you will nor-
mally be able to use it again.
Questions and answers
If you have any queries about the use of
your telephone, you can contact us at any
time at
www.gigaset.com/customercare . The
table below contains a list of common
problems and possible solutions.
!
The display is blank.
1. The handset is not switched on.
¥
Press and hold the end call key
a
.
2. The battery pack is flat.
¥
Charge/replace the battery pack
(page 8).
The handset does not respond to a key press.
The keypad lock is activated.
¥
Press and hold the hash key
#
(page 13).
"Base station x" is flashing in the display.
1. The handset is outside the range of the base
station.
¥
Reduce the distance between handset/
base station.
2. The base station's range is reduced because
eco mode is activated.
¥
Deactivate eco mode (see page 9) or
reduce the distance between the hand-
set and the base station.
2
3.
The handset has been de-registered.
¥
Register the handset (page 31).
3
4.
The base station is not switched on.
¥
Check the base station mains adapter
(page 6).
Base Search is flashing in the display.
The handset is set for Best Base and no base sta-
tion is switched on or within range.
¥
Reduce the distance between handset/base
station.
¥
Check the base station mains adapter
(page 6).
Handset does not ring.
1. The ringtone is switched off.
¥
Activate the ringtone (page 38).
2. Call diversion set to All Calls .
¥
Switch off Call Diversion (page 16).