Siemens FM 458-1 DP, Manual

Page: 61 / 79

SIMOLINK drive coupling
5-4
Function Blocks - FM 458-1 DP
Edition 12.2004
10 Cyclic-automatic-mode 10
The cyclic-automatic-mode 10 offers the advantage to place the function block configuration in
cyklic tasks, in opposed to mode 3.
NOP
cyclic Task Tx
SYNC Telegram SYNC Telegram
cycle
cycle
cycle
Processing time of the
SIMOLINK blocks Processing time of the
SIMOLINK blocks Processing time of the
SIMOLINK blocks
NOTE
It is necessary to set interrupt task sources for operating modes
0, 2, 3, 4 and 10, in order to initiate the configured interrupt tasks.
The settings must be made in the HWConfig in the properties
window under the "Interrupt tasks" tab. They are dependent on
the configured hardware components.
Interrupt source to be set for the interrupt task Ix of the SIMOLINK blocks, if:
Operating
mode
first SLB module at
slot 1
first SLB module at
slot 2
second SLB
module at slot 1
second SLB
module at slot 2
0 LE bus interrupt 1 LE bus interrupt 3 LE bus interrupt 2 LE bus interrupt 4
2 LE bus interrupt 5 LE bus interrupt 6 LE bus interrupt 7 LE bus interrupt 8
3 LE bus interrupt 1 LE bus interrupt 3 LE bus interrupt 2 LE bus interrupt 4
4 LE bus interrupt 1 LE bus interrupt 3 LE bus interrupt 2 LE bus interrupt 4
NOTE The first SLB module can be an EXM 448-1- or an ITSL module
without optional SLB. The settings for the second SLB module
are only relevant for an ITSL module with optional SLB.
interrupt task
settings