27
FLUDEX 4612 en
Operating instructions 10/2017
NOTICE
Damage to the coupling, damage to other components
Risk of damage to the coupling through fitting forces by way of the aluminium housing.
Under no circumstances must fitting forces be applied through the aluminium housing, to avoid damage
to the coupling parts.
Always use suitable lifting equipment.
NOTICE
Damage to the shaft and the coupling parts
Damage caused by incorrect positioning of the coupling parts on press fits.
The information specified on the dimensioned drawing must be observed.
Heating the coupling hubs (to m 150 °C) may facilitate fitting. With temperatures over + 80 °C
the flexible elements must be removed from the coupling part 1 before heating.
DANGER
Risk of explosion
Risk of explosion when exceeding the ignition temperature, when using a burner or similar equipment.
Burner and heated coupling parts form an explosion hazard; therefore a nonexplosive environment
must be ensured.
WARNING
Risk of burns
Serious injury through burns on hot surfaces (> 55 °C) possible.
Wear suitable protective gloves and protective clothing.
•
The coupling hubs must be fitted using the entire length of the bore or until they come into contact with
the shaft shoulder.
•
After being pulled on, the coupling hubs must be secured axially by means of a locking plate and
a retaining screw or a set screw (see item 6.1.3).
Note
Tighten the set screws to the tightening torque specified in item 6.1.4.
Summary of Contents for FLENDER FLUDEX FNA
Page 2: ......
