SIEMENS ADSL E-110_E-110-I user manual
RIP Configuration
Your ADSL Router can be configured to communicate with other routing devices to determine the best
path for sending data to its intended destination. This chapter describes how to configure your ADSL
Router to use one of these, called the Routing Information Protocol (RIP).
Most small home or office networks do not need to use RIP. You may want to configure RIP if any of the
following circumstances apply to your network:
•
Your network includes an additional router or RIP-enabled PC. The ADSL Router and the router will
need to communicate via RIP to share their routing tables.
•
Your network connects via the ADSL line to a remote network, such as a corporate network. In order
for your LAN to learn the routes used within your corporate network, they should
both
be configured
with RIP.
•
Your ISP requests that you run RIP for communication with devices on their network.
Configuring the RIP
1. Select
to
Services
>
RIP
. The
RIP Configuration
page displays.
2. If necessary, change the
Age
and
Update Time
.
These are global settings for all interfaces that use RIP.
Age is the amount of time in seconds that the device’s RIP table will retain each route that it learns
from adjacent computers.
Update Time specifies how frequently the ADSL Router will send out its routing table its neighbors.
3. In
the
IF Name
column, select the interface on which you want to enable RIP.
For communication with RIP-enabled devices on your LAN, select eth-0 or the name of the
appropriate virtual Ethernet interface.
For communication with your ISP or a remote LAN, select the corresponding PPP, EoA or other WAN
interface.
4. Enter a metric value (hop count) for the interface. You can enter any integer from 1 to 15.
5. Select
a
Send Mode
and a
Receive Mode
.
The Send Mode setting indicates the RIP version this interface will use when it sends its route
information to other devices.
The Receive Mode setting indicates the RIP version(s) in which information must be passed to the
ADSL Router in order for it to be accepted into its routing table.
RIP version 1 is the original RIP protocol. Select RIP1 if you have devices that communicate with this
interface that understand RIP version 1 only.
RIP version 2 is the preferred selection because it supports “classless” IP addresses (which are used to
create subnets) and other features. Select RIP2 if all other routing devices on the autonomous
network support this version of the protocol.
54
Rev:01_040220
