Siemens CR-IR 347, Service Manual, Page: 20 / 123

CR-IR347 Service Manual PM - 15.1 009-058-03
08.30.2002 FM3476
PM - 15.1
■
Check for Format
Make sure that the white blank portion, as measured from the outermost side of the image
border of the output film, is 2 mm or less in actual size on the IP.
◆
CHECK
◆
Make sure that the white blank portion is 2 mm or less.
If anything abnormal is found, refer to the “Troubleshooting” volume.
◆
NOTE
◆
The distance measured on the film may differ from the actual size on the IP, depending
on the reading size or film size. Using the distance measured on the film and the
reduction factor for the film, calculate the actual size on the IP. Compute the actual
size on the IP according to the following formula.
REFERENCE
For example, when a two-in-one image of 14"x14" (35cm x 35cm) is outputted to B4
film, the resulting reduction factor is 50%. If the distance measured on the film is 1
mm, then actual size on the IP is 2 mm. Calculate the distance in actual size on the IP
as shown below.
Image border
White blank portion
2 mm or less
FR7H6055.EPS
TR7H6010.EPS
Actual size on IP = Measured value x
100
Reduction factor (%)
FR7H6960.EPS
Film
1mm
■
50%
100
50 (%)
Actual size on IP: Measured value x =1 (mm) x = 2 (mm)
100
Reduction factor (%)
The reduction factor is indicated here.