BTC-BR User’s Manual
18
Steps
Contents of the display Keys
Procedures
24
25
Note:
In this function can be used the
F1
key to help in the edition of the vehicle identification. This key
alternate the editing mode between overwrite or insert character. While on the screen of the
programmer the description
F1-SUB
the editing mode will allow to insert new characters erasing the
first from left to right. When is the function
F1-INS
, will be available the mode of replacement only
from the selected character. To enter the characters in yellow press
F3
(from A to M), for the green
characters press
F4
(from N to Z), and for numbers press
F2
(from 0 to 9). At this moment the
corresponding led to the mode selected will remain on (for letters) or off (for numbers).
Steps
Contents of the display Keys
Procedures
26
27
28
Note:
the function “Over Speed” will be valid only for MTCO models that have, in their “Product
Code”, the numbers 007 and 008 in position hhh (see Information Service T033/02).
12. INITIAL INSTAL.
13. CALIBRATE DATE
14. SEAL NUMBER
←
(
5
/
6
) – Scroll
(
E
) Enter
SEAL NUMBER
[SIEMENS VDO]
F1-SUB
(
E
) – Adjust
(
C
) Exit
Select Seal Number
Function of control. It records the number or
name of the person responsible for last
measurement of MTCO. Important function in
the control of those responsible for
measurements made.
To record the desired information, press
L
to
clean the field of editing, enter the desired
name/number and press
E
. In case of wanting
replace only one character, press
F1
, select
the desired character and enter the new value
for it.
13. CALIBRATE DATE
14. SEAL NUMBER
15. OVER SPEED
←
(
5
) – Scroll
(
E
) Enter
OVER SPEED
[- - - -] km/h
READING MTCO
(
E
) – Adjust
(
C
) Exit
Select Over Speed
This function allows adjusting the speed
from which a light or sound device could be
triggered, activated by the
D4
output of
MTCO.
At this moment the calibrator will check what is
the value pre-adjusted to the MTCO. This will
be possible only if the tachograph have that
function.
OVER SPEED
[080] Km/h
(
E
) – Adjust
(
C
) Exit
After reading the pre-adjusted value will be
possible reprogram it.
In case of wanting to correct the trigger point of
the external device, press
L
to clean the field of
editing, enter the desired value and press
E
.
E
E