BTC-BR User’s Manual
17
Steps
Contents of the display Keys
Procedures
16
17
18
19
20
21
22
23
7. VEHICLE IDENT.
8. CONFIGURATION
←
9. CAN CONFIG.
←
(
5
/
6
) – Scroll
(
E
) Enter
10. PRODUCT CODE
←
11. DRIVE SHAFT
12. INITIAL INSTAL.
(
5
/
6
) – Scroll
(
E
) Enter
10. PRODUCT CODE
11. DRIVE SHAFT
←
12. INITIAL INSTAL.
(
5
/
6
) – Scroll
(
E
) Enter
These functions are not enabling to
tachograph currently in use. They are
included in the configuration of the product
and
must not
be changed in any hypothesis.
Select next function.
This function is not enabling to tachograph
currently in use. Modify since the configuration
of the display until the exhibition modes and
must not
be changed under any
circumstances.
Select next function.
Select Drive Shaft
This function records the relation of reduction
of the rear axle of the vehicle. Auxiliary
function in the mathematical calculation of the
constant”K”.
DRIVE SHAFT
[00,01] I/U
(
E
) – Adjust
(
C
) Exit
In case of wanting to correct the relation of
reduction, press
L
to clean the field of editing,
enter the desired value and press
E
. This
programme is only informative, does not
affect the operation of the tachograph.
10. PRODUCT CODE
11. DRIVE SHAFT
12. INITIAL INSTAL.
←
(
5
/
6
) – Scroll
(
E
) Enter
Select Initial Installation
Function of control. It records the date on which
the MTCO was installed. This function is
optional, however important in tracking the
product.
E
INITIAL INSTALLATION
[05 / 01 / 01]
F1
– Adjust
(
C
) Exit
To register the
Initial Installation
, must be
pressed
E
to change the field, i.e., enter the day
and press
E
, enter the month and press
E
, and
finally enter the year and press
E
. At the end
press
F1
and the date will be effective.
12. INITIAL INSTAL.
13. CALIBRATE DATE
←
14. SEAL NUMBER
(
5
/
6
) – Scroll
(
E
) Enter
E
E
Select Calibrate Date
Function of control. It records the date on which
the measurement of MTCO was made. It is an
optional function, however important in the
tracking of the measurements by which the
MTCO passed.
E
E
CALIBRATE DATE
[05 / 01 / 01]
F1
– Adjust
(
C
) Exit
To register the
Calibrate Date
, must be pressed
E
to change the field, i.e., enter the day and
press
E
, enter the month and press
E
, and finally
enter the year and press
E
. At the end press
F1
and the date will be effective.
E