BTC-BR User’s Manual
16
Steps
Contents of the display Keys
Procedures
9
10
11
12
13
14
15
Note:
In this function can be used the
F1
key to help in the edition of the vehicle identification. This key
alternate the editing mode between overwrite or insert character. While on the screen of the
programmer the description
F1-SUB
the editing mode will allow to insert new characters erasing the
first from left to right. When it is in the function
F1-INS
, will be available the mode of replacement
only from the selected character. To enter the characters in yellow press
F3
(from A to M), for the
green characters press
F4
(from N to Z), and for numbers press
F2
(from 0 to 9). At this moment the
corresponding led to the mode selected will remain on (for letters) or off (for numbers).
4. N - ADJUSTMENT
←
5. WHEEL CIRCUMFER
6. DIST COUNTER
(
5
/
6
) – Scroll
(
E
) Enter
4. N - ADJUSTMENT
5. WHEEL CIRCUMFER
←
6. DIST COUNTER
(
5
/
6
) – Scroll
(
E
) Enter
E
WHEEL CIRCUMFER
[5100] mm
(
E
) – Adjust
(
C
) Exit
This function is not enabling to tachograph
currently in use. It allows adjusting the
constant of adaptation to indication/recording
of engine speeds (RPM).
Select next function.
Select Wheel Circumference
In this function must be registered the
perimeter or radius of the wheel, with tire, from
the vehicle where the MTCO is installed.
Auxiliary function in the mathematical
calculation of the constant”K”.
In case of wanting to correct the value of the
perimeter/radius, press
L
to clean the fields of
editing, enter the desired and press
E
. This
programme is only informative, does not affect
the operation of the tachograph.
4. N - ADJUSTMENT
5. WHEEL CIRCUMFER
6. DIST COUNTER
←
(
5
/
6
) – Scroll
(
E
) Enter
Select Distance Counter
This function allows programming the total
distance traveled in the equipments of
exchange and keeping them as the original
vehicle mileage.
DISTANCE COUNTER
[0013586] Km
(
E
) – Adjust
(
C
) Exit
In case of wanting to correct the kilometers
traveled, press
L
to clean the field of editing,
enter the desired value and press
E
.
E
7. VEHICLE IDENT.
←
8. CONFIGURATION
9. CAN CONFIG.
(
5
/
6
) – Scroll
(
E
) Enter
This function allows logging the vehicle
identification where the MTCO will be installed.
This function is an item of security and will help
in cases of traceability of equipment.
VEHICLE IDENTIF.
[9BWV2VD23YRY03520]
F1-SUB
(
E
) – Adjust
(
C
) Exit
E
E
In case of wanting to correct the vehicle
identification, press
L
to clean the field of editing,
enter the desired value and press
E
. In case of
wanting to replace only one character, press
F1
,
select the desired character and enter the new
value for it.