Siemens 7MB2335, Operating Instructions Manual, Page: 91 / 168

Operation
5-41
Operating instructions ULTRAMAT 23 gas analyzer
C79000-B5276-C216-03
The deviation is still displayed with the 4th AUTOCAL; at the same time
the value of the 4th AUTOCAL is used as the new reference value. If
an error message ’AUTOCAL deviation too large’ is acknowledged, the
values are reset during the next AUTOCAL, and counting commences
at 1 again.
5.10.2.3 Configuration: Special Functions: ELAN/PROFIBUS
You can use this dialog to set the parameters for an ELAN or
PROFIBUS network (see Chapter 3).
S
ELAN Parameters
You can use this dialog to set the parameters for an ELAN network
(see Chapter 3).
Channel
Here you can set the channel address for this analyzer.
Addresses from 1 to 12 can be set. Each address may only be
used once in an ELAN network.
Name
You can set an analyzer name here. During communication with
ELAN, it can be used for the plain text identification of the
analyzers.
Protocol (ON/OFF)
The cyclic, automatic transmission of measured values every
500 ms can be switched on/off.
Sync. zero cal. (ON/OFF)
This function is not yet available. It must be set to OFF.
Notice
For further details on the ELAN, please refer to the ELAN interface
description (C79000-B5274-C176 German/English)
S
ELAN ext. Interfer.
Parameterization with two analyzers is used as an example.
Analyzer 1 delivers measured values, analyzer 2 uses these values
for a correction calculation.
ELAN Parameters
ELAN ext.Interfer.
PROFIBUS Parameters
Const. Interfer.
51023
Channel : 1
Name: ULTRAMAT 23
Protocol
:OFF
Sync. zero cal. :OFF
51023a