Siemens Healthcare Clinitek Status Connect System, Operator'S Manual

Page: 18 / 80

CAUTION
If the instrument uses the operator list sent by the LIS, do not
power down the system. If the connector loses power, the
operator names are erased.
NOTE:
The operator list sent by the LIS overwrites an operator list entered via
the analyzer.
Adding Operator IDs
To add operator IDs, perform the following steps:
1. At the
Authorized operator screen, select Add operator .
2. Enter the new Operator ID.
Use the alpha keyboard to enter text.
To enter numeric text, select
123 .
3. Select Enter .
The Authorized Operator screen displays indicating the Operator ID and
which functions the operator can perform.
4. To edit this Operator ID, select Edit .
5. To edit which functions this Operator ID can access, select Edit .
The Authorized Operator-Operator access screen 1 of 2 displays.
6. To allow this operator to run patient tests, select Enabled .
To prevent patient tests, select Disabled .
7. To allow this operator to run QC tests, select Enabled .
To prevent QC tests, select Disabled .
8. Select Next .
The Authorized Operator-Operator access screen 2 of 2 displays.
9. To allow this operator to recall results, select Enabled .
To prevent recall results, select Disabled .
10. To allow this operator to set up the instrument, select Enabled .
To prevent instrument setup, select Disabled .
11. Select Done twice.
The Authorized Operator-Operators list screen displays.
12. Select Exit .
13. Select Done 3 times to return to the Select Ready screen.
Viewing, Editing, Printing, and Deleting Operator IDs
You can view, print, or delete the entire operator list or edit individual
operators.
NOTE:
If you delete the entire operator list, ensure that authorized operators is
Disabled. See Setting Operator IDs above.
Clinitek Status Connect System 18 Operator’s Guide