SICLI COP3000, Installation Manual, Page: 4 / 45

COPP420 Analogue photoelectric sensor, this is the
most commonly used Sensor and is most suitable for
detecting slow burning fires.
The status LED can be programmed to either be
permanently off under normal conditions or to pulse in
order to confirm that it is in communication with the
COP3000 control panel.
COPOH450 Analogue photo/thermal sensor, this is a
new addition to the Cooper Fire Systems range of sensors.
It is the ideal Sensorfor a multi-use environment as it has
an excellent response to smouldering and fast burning
fires. photo/thermal sensors can be programmed for
thermal only operation at certain times of day
The status LED can be programmed to either be
permanently off under normal conditions or to pulse in
order to confirm that it is in communication with the
COP3000 control panel.
The range of compatible sensors for the COP3000 system consists of the following:
COPH430 Analogue heat sensor,
Heat sensors are suitable for dusty environments or
environments where smoke is likely to be present under
normal operating conditions. The CAH330 can be
programmed to operate in A1R, BS or CS mode of
operation depending on the required application and
sensitivity requirements.
The status LED can be programmed to either be
permanently off under normal conditions or to pulse in
order to confirm that it is in communication with the
COP3000 control panel.
Compatible Equipment
4
www.acornfiresecurity.com
www.acornfiresecurity.com