3 D D R I V E R A S S I S TA N C E S Y S T E M | V I S I O N A R Y - B
8022960/ 2018-07-16| SICK AG
Subject to change without notice
7 8
ELECTRICAL INSTALLATION
3. Connect the evaluation units to the power cable for the vehicle's electrical system
(2).
6.6
Connecting the evaluation unit to the vehicle's electrical system
IMPORTANT!
Before commencing the electrical installation, check where the connections are to be
located. You must refer to the operating instructions issued by the vehicle manufacturer
at this stage.
Pin
Flex color
Description
1
White
GND
2
Brown
+Battery
3
Gray
+Ignition
4
Green
+ Discrete signal input (reverse gear)
5
Yellow
+ Discrete signal input (optional recorder deactivation)
6
Pink
+Discrete Signal Input (reserved)
1. Connect the power supply to the vehicle's electrical system as shown in the above
table (fuse box).
2. Use heat-shrinkable sleeves to insulate any exposed joints.
IMPORTANT!
Protect the evaluation unit against electrical overstress. To do this, you can use the
supplied fuses.
Please note that failure to observe this measure will
invalidate any warranty claims..
