Approach
1.
Unscrew the red button of the escape release.
2.
Extend the escape release shaft if necessary.
3.
Insert the escape release shaft through the hole.
4.
Mount the safety switch using 4 × M5 screws.
5.
Screw on the red button of the escape release.
5.7
Mounting the emergency unlocking
Approach
1.
Remove the center screws on the cover of the safety switch.
2.
Remove the retaining screw of the mechanical unlocking mechanism.
3.
Position the emergency release so that the blade of the emergency release can
reach into the slot of the mechanical unlocking mechanism.
4.
Ensure that the emergency release is blocked by the ball catch, not by the stop
bolt.
5.
Fasten the emergency release using the included screws M3 × 17. Tighten the
screws to 0.5 Nm.
6.
Seal the emergency release.
1
Figure 20: Mounting the emergency release
1
Screws of the safety switch
5.8
Mounting the cover caps
Approach
1.
Turn the cover cap so that the point is pointing upward.
2.
Insert the cover caps onto the pushbuttons.
3.
Press on the cover caps until they audibly snap in.
MOUNTING
5
8023119/15LY/2019-10-28 | SICK
O P E R A T I N G I N S T R U C T I O N S | TR110 Lock
27
Subject to change without notice
