•
PoE voltage supply is only activated by the relevant app after the boot process
•
Information on available performance
see "Mechanics and electronics", page 27
6.5.3
SENSOR
1
4
3
5
2
Table 4: SENSOR pin assignment, M12 – 5-pin, A-coded, female
Pin
Signal
Function
Factory settings
1
+24 V
Supply voltage for
peripherals, configura‐
ble
Deactivated
2
Input 2
Digital input
-
3
GND
Ground
-
4
C/Q or Input 1 / Out‐
put 1
C/Q IO-Link or configu‐
rable switching input/
output
All IO connections con‐
figured as inputs
5
NC
Not connected
-
Housing
-
Screen
-
Additional notes
•
IO-Link master
•
The digital inputs and output on SENSOR are switchable, regardless of whether
the supply voltage is activated at Pin1. A ground connection on Pin3 is required in
all cases.
•
digital output
°
Max. output 100 mA
°
Min. high output logic level: 21 V
°
Max. low output logic level: 3 V
°
Push-pull switch
°
Max. IO-Link output frequency: 230 kHz
°
Max. IO output frequency: 30 kHz
•
Digital inputs
°
Min. high input logic level: 12 V
°
Max. low input logic level: 4 V
°
Max. IO-Link input frequency: 230 kHz
°
Max. IO input frequency: 30 kHz
•
Max. 1 A output for supply voltage connection (compliant with LPS)
•
HTL encoders use push-pull switches and can therefore be connected via the
digital inputs.
Recommendation when using SENSOR for illumination
Short flash times can be achieved by using an illumination unit with signal strobe and
by using pin4 as a digital output signal with a constant supply voltage on pin1 (Signal
Strobe Mode).
The SIM1004
does not
support Power Strobe Mode via the "Connector.Power.Gate” API.
6.6
Connecting peripheral devices
The device can be connected to a wide range of sensors and cameras.
ELECTRICAL INSTALLATION
6
8023516/1BQH/2021-07-28 | SICK
O P E R A T I N G I N S T R U C T I O N S | SIM1004
19
Subject to change without notice
