104
FLOWSIC100 Flare-XT · Operating Instructions · 8023761/V1-0/2020-10 · © SICK Engineering GmbH
Installation Interface Unit
6.4.6
Fitting the tag plate (available as option)
Two versions of the tag plate are available:
● As label
The label with the tag number is already glued on at the factory when this variant is
selected.
● As label with an additional stainless steel tag plate
The label with the tag number is already glued on at the factory when this variant is
selected and the additional stainless steel tag plate then attached after electrical
installation. This Section describes fitting the stainless steel tag plate.
Fig. 61
Overview
Fitting the stainless steel tag plate
▸
Before fitting the tag plate ensure it is the correct tag plate. Compare the tag plate with
the tag number on the Interface Unit.
▸
Fit the tag plate.
The tag plate assembly kit comprises 4 screws with different lengths (2 short, 2 long)
and one contact disc:
– Use both longer screws for the Interface Unit with NPT cable entries (with flange
plate): For fitting the tag plate, first unscrew two screws from the flange plate and
replace these with the longer screws. Fit the contact disc with one of the two screws
between the screw head and tag plate.
– Use both shorter screws for the Interface Unit with metric cable entries (without
flange plate): Fit the contact disc with one of the two screws between the screw head
and tag plate.
NOTICE:
▸
Fit the tag plate after the electrical installation in
.
2
1 Label with tag number
2 Stainless steel tag plate
1
WARNING:
Hazard through electrostatic discharge
Fit the contact disc provided with one of both screws.
The contact disc ensures the stainless steel tag is securely earthed via the
screw-on point.
