![background image](http://html.mh-extra.com/html/sick/flexi-classic-series/flexi-classic-series_operating-instructions-manual_1264302118.webp)
Chapter
13
Operating instructions
Flexi Classic
118
© SICK AG • Industrial Safety Systems • Germany • All rights reserved
8011509/YPP0/2015-10-26
Subject to change without notice
Annex
13
Annex
13.1 Compliance with EU directives
EU declaration of conformity (excerpt)
The undersigned, representing the following manufacturer herewith declares that the
product is in conformity with the provisions of the following EU directive(s) (including all
applicable amendments), and that the respective standards and/or technical specifica-
tions are taken as the basis.
Complete EU declaration of conformity for download: www.sick.com
13.2 Manufacturer’s checklist
Κ
Checklist for the manufacturer/installer for installation of the Flexi Classic modular safety controller
The information for the points listed below must at least be available the first time the equipment is commissioned.
They depend on the application the requirements of which must be verified by the manufacturer/installer.
This checklist should be retained and kept with the machine documentation to serve as reference during recurring
tests.
1. Have the safety rules and regulations been observed in compliance with the directives/standards
applicable to the machine?
Yes
No
2. Are the applied directives and standards listed in the declaration of conformity?
Yes
No
3. Does the protective device comply with the required category?
Yes
No
4. Are the required protective measures against electric shock in effect (protection class)?
Yes
No
5. Has the potective function been checked in compliance with the test notes of this
documentation? In particular:
•
functional check of the input devices, sensors and actuators connected to the safety controller
•
test of all switch-off paths
Yes
No
6. Are you sure that the safety controller was tested fully for safety functionality after each
configuration change?
Yes
No
This checklist does not replace the initial commissioning and regular tests by qualified safety personnel.