5
Use and maintenance Manual AUTOMATIC GENSET CONTROL PANEL
with GC310/GC350
Do not carry out or try to perform actions of start-up, maintenance, reparation or
modification you have neither the specific expertise nor the precise instructions.
If any doubt persists after reading the following paragraphs and attachments, please
do not hesitate to contact SICES Technical Service. All actions must always be
performed complying with safety regulations.
We recommend to check that the Control Panel is intact after unpacking. In case of doubts, do not
use it, but refer to the manufacturer under penalty of warranty nullity.
Before proceeding to the installation, ensure you checked and observed the following indications:
-
All installation operations must be performed by skilled personnel who strictly observe the
safety regulations in force in the country where the installation takes place;
-
Ensure that the data on the identifying label of the control panel comply with the plant values;
in detail, check the power, the voltage, the current and the frequency;
-
For the electric connection, strictly follow the enclosed electric diagram, which contains useful
information;
-
In the connection of the power and command lines, we recommend to guarantee at least the
section value suggested;
-
Ensure that the connection of the earthing protection conductor is always connected,
compatibly with the distribution system and the regulations in force in the country of issue;
-
Ensure that the conductors of the auxiliary circuit are correctly connected. Also check
the correct connection of the phase and neutral conductors.
A wrong or missed neutral conductor connection may cause serious damages
to the Control Panel and to the distribution plants connected to it.
Install the control panel according to the protection degree. We recommend the use of a cable press
with the same characteristics, in order to avoid a decrease of the protection value.
The control panels must be installed properly. Any faults, modifications to the original project,
interferences from external agents such as plants, animals, dust, mould, etc. must be removed or
restored to the default values.
Summary of Contents for GC310
Page 32: ......
