25
Use and maintenance Manual AUTOMATIC GENSET CONTROL PANEL
with GC310/GC350
Do not perform or undertake any start-up operation, maintenance, repair or change
without precise knowledge or proper instructions.
All operations must be carried out in accordance with all safety norms.
WARNING
THE ELECTRICAL PANEL IS SUPPLIED BY TWO DIFFERENT SOURCES, THE
MAINS AND THE GENSET. THE ELECTRICAL PANEL IS LIVE EVEN WHEN THE
DOOR IS OPEN.
Before carrying out any maintenance operation, ensure that both Mains and Genset lines are clear
of voltage. If the electrical panel is equipped with protection barriers that were removed for
installation or maintenance purposes, these must be reapplied afterwards.
Do not disassemble or force any electric part as the panel has live wires.
The key for the electrical panel must be given to authorised staff only.
WARNING
SUBJECT
PRECAUTION
DANGER
All maintenance operations must be carried out by trained
and informed staff only.
All maintenance and check operations must be carried out
with genset in block mode and after the panel has been
isolated from all external energy fonts.
PAY PARTICULAR ATTENTION TO UNITS WITH
AUTOMATIC OR REMOTE START SYSTEMS:
- AUTOSTART;
- MAINS FAILURE SENSOR;
- PROGRAMMABLE FUNCTION FOR AUTOMATIC TEST.
THESE ARE ALL FUNCTIONS THAT, IF THE GENSET IS
NOT IN BLOCK MODE, CAN ALLOW IT TO GET
STARTED
EVEN
DURING
MAINTENANCE
OPERATIONS,
CAUSING
DANGER
TO
THE
TECHNICIAN WORKING ON THE UNIT.
Disconnect the devices supplied by the mains, as
preheating systems or mains sensing control.
All operations requiring the removal of the protection
barriers must be done in the above mentioned conditions
only. If the protections are removed, these must be
reapplied before the next start-up.
Remove voltage supply and turn off the unit in case of malfunction or fault
.
It is forbidden to change the electric panel parts, the position of the components and/or any
mechanical and electrical components.
The lack of respect for the above recommendations may compromise the panel safety and it is
immediate decay of the warranty. Any change made to the panel will be responsibility of the executor
of the change that then becomes the manufacturer.
Summary of Contents for GC310
Page 32: ......
