96
FAAC
Duplication requires MASTER* RC
1.
Simultaneously press the first 2 buttons of the RC MASTER
already operating in receiver** and keep them pressed until
the RC MASTER LED flashes. Release both buttons.
2.
While LED is flashing, put the operating RC MASTER in
receiver close to the front of the NEW RC (to be coded).
3.
On the RC MASTER (already working in receiver), while LED
is still flashing, press and hold the first key you wish to
duplicate. LED of the same will light up steadily.
4.
On the new RC (to be encoded), press the equivalent button
to be copied and release it only when LED on the new RC
MASTER has flashed twice.
5.
Release the RC MASTER button (already working in
receiver).
6.
Repeat the procedure for as many buttons you want to
copy.
If the process is not successful or if errors are made during programming, wait 20 seconds and
start the programming process again from point 1.
*To recognise an RC Master, press any RC button already operating in the receiver and check
what type of flashing the RC Master LED is emitting:
- if it emits a short flash before switching on with a steady light it is a MASTER and can be
duplicated by following the process described in this page.
- if it lights up immediately at fixed light it is an RC SLAVE and cannot be duplicated. In this case
you should only contact the installer of the automation.
**Warning! Do not confuse the two RCs: the MASTER RC already working in receiver and the new
one to be coded.
XT2 868 SLH LR BIANCO
Cod.
6900987
XT4 868 SLH LR BIANCO
Cod.
6901003
XT2 868 SLH LR NERO
Cod.
6901031
XT4 868 SLH LR NERO
Cod.
6901032
Compatible with FAAC TML2/TML4 868, FAAC T2/T4 868, FAAC DL2/DL4 868 RCs
868.35 MHz
Hopping code
DUPLICABLE THROUGH UNIVERSAL RCs
EVO
Summary of Contents for 4790786
