91
DEA
The RC is supplied with rolling-code option. To change the encoding type,
proceed as follows:
1.
Press and hold button 1 (until the end of the procedure). LED has steady light.
2.
Now press button 2 to change the encoding type:
(a) 1 flash per second= Rolling Code
(b) 2 flashes per second= Fix code
- Always keeping button 1 pressed, also press and hold button 2. LED goes off
for 2 seconds, lights up again permanently and then goes off again.
- Release both buttons now.
N.B.
Green LED = fix code
Red LED = rolling code
FIX CODE PROGRAMMING
1.
Press and hold down the button of the new RC you want to copy. The green
LED starts flashing.
2.
Position the operating RC as shown in the figure.
3.
Press and keep pressed the button of the operating RC until LED stays steady
for 1 second and then turns off.
4.
The duplication was successful.
ROLLING PROGRAMMING
1.
Using a pin, press the hidden button on the lower left side of the RC already
working in the receiver.
2.
Press the button of the new RC you want to memorise. Wait 10 seconds and
try to open the gate.
NB: if the memorisation operation is unsuccessful, act directly on the receiving
CU in the following way:
• Press the programming button P1 on the receiver unit and release it.
• Press the button on the new RC you want to memorise and release it.
• Wait 10 seconds and try to open the gate.
GT2M
Cod.
6901606
GT4M
Cod.
6901607
Compatible with DEA TX4 OLD, DEA PUNTO-4, DEA 433-4, TD2, TD4 RCs
P1
433.92 MHz
Fix code
DUPLICABLE THROUGH UNIVERSAL RCs
EVO
LITE
Summary of Contents for 4790786
