Sibata 090860-0341, Operation Manual

Page: 17 / 44

- 15 -
Preparing for Operation
Make sure that the wiring and piping have been properly connected.
Turn ON the power switch on the side of the pump body.
The version and flow rate conversion temperature value are displayed on screen, and the screen
changes as follows.
* When using the pump for the first time, the manual mode screen will be displayed. Normally, the
screen for the mode used in the previous measurement is displayed.
* The battery status mark is not displayed when the pump is operated from the AC power source.
Each press of the MODE key switches the screen cyclically as follows: manual mode → down timer
mode → volume timer mode → cycle timer mode → memory → extra menu.
Each press of the MODE key switches the segment to light on the mode display bar at the top of the
LCD screen to indicate the current mode.
MA: manual mode
DT: down timer mode
VT: volume timer mode
CY: cycle timer mode
SET: setup in progress (Not displayed using only the MODE key.)
The mode display bar is not lit in the memory and extra menu screens.
Down timer mode Manual mode
Extra menu
Memory
Volume timer mode
Cycle timer mode