Sibata 090860-0341, Operation Manual

Page: 12 / 44

- 10 -
Wiring Methods
When Used with the AC Power Source
The pump can be operated by an AC power source by connecting the QC-10KN Quick Charger
(sold separately) directly to the pump body. Also, the pump can be operated and the LI-10KN (sold
separately) charged at the same time with the LI-10KN installed.
Even if the AC adapter PA-1203 (sold separately) is connected to the pump body, the body can be
operated; however, the LI-10KN cannot be charged.
When Using the Battery
The pump can be used by installing the LI-10KN or DB-10N.
The battery status mark is displayed on the screen when the power is turned ON with the battery
installed. (It is not displayed when the AC power source is connected.)
Battery
status
70% or more power
30% or more power
Less than 30%
0% The pump stops operating. The battery must be recharged or replaced
immediately.
* When a battery other than an alkaline battery is used on the DB-10N, the battery status icon will
not function properly.
* Do not remove the battery during pump operation.
* The battery can be replaced with the DB-10N installed on the pump body. However, before
replacing the battery, be sure to turn the pump OFF.
If the pump is operated from the AC power source with the battery inside, the power source
will automatically switch to the battery in the event of a power interruption, and
measurement can be continued in this state.
In cases such as this, measurement can be performed more safely by using the Quick
Charger QC-10KN as the AC power source and the Battery Holder LI-10KN as the battery
since the battery is automatically charged after AC power is restored.
PA-1203
QC-10KN