Si-tex SNS-1100, User Manual

Page: 28 / 114

28
- User Manual
• Fishing Facility
• Dredged Areas
• Diffusers
• Mooring/Warping Facility
• Production Installation
• Pingos
• No Data Available
If any of these alarm conditions is detected, then the chart plotter highlights the list of dangerous
objects and the correspondant dangerous Route leg. The Route leg is then drawn in a different
color.
It is possible to make the Safe Route Check from menu following the procedure:
[MENU] + “Route” + [ENTER] + “Route Check Report” + [ENTER]
or:
Place the cursor on the desired Route leg + [Check]
The list of the dangerous objects found on the charts crossed by the Route is shown in the
Route check report.
It is also possible to activate this function in automatic mode:
[MENU] + “Route” + [ENTER] + “Automatic Route Check” + [ENTER] + “On” + [ENTER]
If Automatic Route Check is activated, the modified Route legs are checked everytime a
Waypoint is added, inserted, edited or moved.
Before activating the function, you could change the function parameters, as the width and the
depth of the detected area and the research accuracy.
To select the width of the detected area aside the Route:
[MENU] + “Route” + [ENTER] + “Route Width” + [ENTER] + insert the desired value +
[ENTER]
NOTE Safe Route width value represents half the total width checked by the function.
To select the depth of the detected area aside the Route:
[MENU] + “Route” + [ENTER] + “Route Depth” + [ENTER] + insert the desired value +
[ENTER]
It also possible to select the accuracy for the Route check, among Minimum, Low, Medium, High
and Maximum:
[MENU] + “Route” + [ENTER] + “Route Check Accuracy” + [ENTER]