Shuttle TNT, Assembly Manual

Page: 9 / 20

Page 9
STEP 4 INSTALLING THE SEAT
ITEMS
REQUIRED
CARRIAGE
SEAT
1. Turn the Seat upside down with the Cushion laying on the ground. Remove the 4 lock nuts
and washers from the bolt studs. (Pic 4.1)
2. Unscrew and remove the Barrel Nut from the Carriage. Lift the Handle Bar Frame from the
Cushion and align bolt holes “13”, “14”, and “15.” (Pic 4.2)
3. Place the Seat Cushion into the corresponding holes of the Carriage and Handle Bar
Frame. (Pic 4.3)
4. Tighten down the Barrel Nut to bolt “15.” Tighten 2 thick lock nuts with washers to the rear
bolt studs on the Seat Cushion. Tighten 2 shallow lock nuts with washers to the last two
remaining bolt studs on the Seat Cushion.
Adjusting Handlebars: Twist the knobs
counterclockwise to loosen. Adjust to desired
position and tighten by twisting clockwise.
Pictures are on the next page