Shuttle TNT, Assembly Manual

Page: 6 / 20

Page 6
STEP 2 ATTACHING THE HEAD-END STAND
ITEMS
REQUIRED
TNT RAILS
HEAD-END
STAND
1. Flip the Rails upside down, exposing 4 lock nuts at the Head-End of the TNT Rails. Remove
the 4 bolts (2 on each side) from the Rails. (Pic 2.1)
2. Align the holes of the Head-End Stand with the now exposed bolt holes on the TNT Rails.
The Head-End Stand should be flipped upside down so the Rubber Feet are facing up. This
step is easier with two people. (Pic 2.2)
3. From the underside of the TNT Rails, insert the 4 bolts into and through the Head-End
Stand. Hand tighten the lock nuts. It is important to make sure the lock nuts are against the
Head-End Stand as they will interfere with the Carriage if they are along the TNT Rails. (Pic
2.3)
2.1
2.3 2.2