- 68 -
UART 2 Mode
This item allows you to select which mode for the Onboard Serial
Port 2.
Ø
The choice: Standard, HPSIR, or ASKIR.
IR Function Duplex
This item allows you to select the IR half/full duplex funcion.
Ø
The choice: Half or Full.
TX, RX inverting enable
This item allows you to enable the TX, RX inverting which depends
on different H/W requirement. This field is not recommended to
change its default setting for avoiding any error in your system.
Ø
The choice: No, No, No,Yes, Yes, No, or Yes, Yes.
Onboard Parallel Port
This item allows you to determine onboard parallel port controller
I/O address setting.
Ø
The choice: 378/IRQ7, 278/IRQ5, 3BC/IRQ7, or Disabled.
Onboard Parallel Mode
Select an operating mode for the onboard parallel (printer) port.
Select Normal or Compatible unless you are certain your hardware
and software both support one of the other available modes.
Ø
The choice: Normal, EPP, ECP, or ECP/EPP.
ECP Mode Use DMA
Select a DMA channel for the parallel port for use during ECP mode.
Ø
The choice: 1 or 3.
Parallel Port EPP Type
Select a DMA channel for the parallel port for use during ECP mode.
Ø
The choice: EPP1.7 or EPP1.9.
Onboard Legacy Audio
This field controls the onboard legacy audio.
Ø
The choice: Enabled or Disabled.
Sound Blaster
This item enables/disables the onboard Sound Blaster.
