- 14 -
Step 2.
Set Jumpers
This mainboard is jumperless! The default jumper settings have been set
for the common usage standard of this mainboard. Therefore, you do not
need to reset the jumpers unless you require special adjustments as in any
of the following cases:
1. Clear CMOS
2. Enable/Disable LAN Function(MV25N Only)
3. Enable/Disable USB Power On Function
Please refer to section
3.2 Jumper Settings
for the detail information.
Step 3.
Install SDR SDRAM System Memory
To install memory, insert SDR SDRAM memory module(s) in DIMM
slot(s). Note that SDR SDRAM modules are directional and will not go in
the DIMM slots unless properly oriented. After the module is fully in-
serted into the DIMM slots, lift the clips of both sides of the DIMM slot to
lock the module in place.
Step 4
Install Internal Peripherals in System Case
Before you install and connect the mainboard into your system case, we
recommend that you first assemble all the internal peripheral devices into
the computer housing, including but not limited to the hard disk drive
(IDE/HDD), floppy disk drive (FDD), CD-ROM drive, and ATX power
supply unit.
