- 40 -
COM2 Connector (J14)
Pins Assignment:
1=DCD2
3=TX2
5=GROUND
7=RTS2
9=RI2
2=RX2
4=DTR2
6=DSR2
8=CTS2
10=KEY
SIR Connector (J8)
If you have an Infrared device, this mainboard can implement SIR (Standard
IR) transfer function. To enable the IR transfer function, follow these steps:
Pins Assignment:
1=+5V
2=NC
3=IRRX
4=GND
5=IRTX
Note:
Before connect your IR device, please be sure each IR on board pin allocation is
matchable with the pin of the IR device. Otherwise, incorrect IR connection may
do damage to your IR device.
Step 1.
Attach the 5-pin infrared device cable to J8 connector.
(Refer to the above diagram for IR pin assignment.)
Step 2.
Configure the Infrared transfer mode in field "UART 2 Mode " of "Integrated
Peripheral" sub-menu in BIOS setup program. This mainboard supports HPSIR,
ASKIR, Standard transfer modes.
Wake-On-LAN Connector (WOL1)
Attach a 3-pin connector through the LAN
card which supports the Wake-On-LAN
(WOL1) function. This function lets users
wake up the connected system through the
LAN card.
Pins Assignment:
1=5V_SB
2=GND 3=RING#/GPI7
9
7
5
3
1
10
8
6
4
2
5 4 3 2 1
E3
E4
E5
J14
1
J8
IR
1
WO
L1
1
1
2
3
