- 61 -
Primary/Secondary Master/Slave UDMA
Ultra DMA/100 implementation is possible only if your IDE hard
drive supports it and the operating environment includes a DMA
driver (Windows 95 OSR2 or a third-party IDE bus master driver). If
both of your hard drive and your system software support Ultra
DMA/100, select Auto to enable BIOS support.
Ø
The choice: Auto or Disabled.
VIA OnChip PCI Device
Options are in its sub-menu.
Press <Enter> to enter the sub-menu of detailed options.
VIA-3058 AC97 Audio
Enables and disables the onboard audio chip. Disable this item if
you are going to install a PCI audio add-on card.
Ø
The choice: Auto or Disabled.
VIA-3068 MC97 Audio
Enables and disables the onboard modem. Disable this item if you
are going to install an external modem.
Ø
The choice: Auto or Disabled.
Super IO Device
Options are in its sub-menu.
Press <Enter> to enter the sub-menu of detailed options.
Onboard FDC Controller
Select Enabled if your system has a floppy disk controller (FDC)
installed on the system board and you want to use it. If you install
add-on FDC or the system has no floppy drive, select Disabled in
this field.
Ø
The choice: Enabled or Disabled.
Onboard Serial Port1/Port2
Select an address and corresponding interrupt for the first and sec-
ond serial ports.
Ø
The choice: 3E8/IRQ4, 2E8/IRQ3, 3F8/IRQ4, 2F8/IRQ3,Auto, or
Disabled.
UART Mode Select
This item allows you to select which mode for the Onboard Serial
Port 2.
Ø
The choice: IrDA, ASKIR, SCR, or Normal.
