- 14 -
Step 2.
Set Jumpers
This mainboard is jumperless! The default jumper settings have been set
for the common usage standard of this mainboard. Therefore, you do not
need to reset the jumpers unless you require special adjustments as any of
the following cases:
1. Clear CMOS
2. BIOS Protect
For first-time DIY system builders, we recommend that you do not change
the default jumper settings if you are not totally familiar with the
mainboard configuration procedures. The factory-set default settings are
tuned for optimum system performance. For the advanced users who
wish to customize their system, section
3.2 Jumper Settings
will provide
detailed information on how to configure your mainboard manually.
Step 3
Install DDR SDRAM System Memory
To install memory, insert SDRAM memory module(s) in any one or two or
three DIMM banks. Note that SDRAM modules are directional and will not
go in the DIMM banks if they are not properly oriented. After the module
is fully inserted into the DIMM bank, lift the clips of both sides of the
DIMM bank to lock the module in place.
