Page 11
STEP 7
INSERTING THE CARRIAGE
ITEMS
REQUIRED
PARTS BAG #7
CARRIAGE
1. While the Carriage is still overturned, grasp both sides of the Range of Motion (ROM)
Control Rope to the center, pull them tight, letting the ROM Control Bar, Donut and
Eyebolts extend over the plate between the wheels to rest on the floor. (Pic 7.1)
2. Keeping the ROM Control Ropes to the inside of the wheels, turn the Carriage over. Insert
the Foot-End of the Carriage into the MVP Rails, and let it gently slide along the track until it
contacts the Rebound Blocks.
This step is easier with 2 people.
(Pic 7.2)
3. Verify the ROM Control Ropes are not crossed. With the Eyebolts on the inside insert the
two forward Eyebolts (closest to the Carriage) outward through the holes of the MVP Rails,
just behind the Carriage. Thread a T-Knob onto each bolt. Make sure the eyebolts are
vertical so the ROM Control Ropes can move freely through the holes. (Pic 7.3)
4. Insert the remaining Eyebolts, following the same method through the MVP Rails just above
the Head-End Stand. (Pic 7.4)
5. To apply the Noise Dampener, run an end of the Dampener over one side of the Rope,
under
the Elasticord Lanyard, up over the other side of the Rope, then join the ends of the
Dampener together
under
the Elasticords. (Pic 7.5)
6. From Parts Bag #7, insert the two Knee Bumpers into the bottom slot of the MVP Rails near
the Head-End Stand so they rest against the rubber cone. (Pic 7.6)
Pictures are on the next page
Summary of Contents for MVP Elite Plus
Page 2: ...Page 2 ...
Page 12: ...Page 12 7 2 7 1 7 3 7 3 7 4 7 6 7 5 ...
