Page 7
STEP 3
MOUNTING THE KICKPLATE STRUCTURE
ITEMS
REQUIRED
KICKPLATE
STRUCTURE
PARTS BAG #3
1. Remove the plywood attached to the bottom and back of the Kickplate Structure. Dispose
of the plywood along with the nuts and bolts that held it together.
2. Position the Foot-End of the MVP Rails to the inside of the Kickplate Structure. Align the
holes and place the MVP Rail ends on the flange of the structure. (Pic 3.2)
3. From outside the Kickplate Structure, insert 3/8” x 2” socket head cap bolts into the interior
four bottom holes (2 on each side) and through the Rails. Gently rock the Stand to align the
remaining 4 exterior bottom holes and insert the bolts. (Pic 3.3)
4. Place the 3/8 “ washers, then the nuts, onto the bolt ends and hand tighten.
5. From the inside of the MVP Rails, insert the 5/16” x 5/8” button head bolts into the top two
parallel bolt holes and out through the Kickplate Structure. Add the lock nuts to the bolt
ends and hand tighten. (Pic 3.5)
6. Tighten all the bolts of the assembled pieces including the Connector Plate, Head-End
Stand/Wings and Kickplate Structure.
Flange
3.2
3.5
3.3
Summary of Contents for MVP Elite Plus
Page 2: ...Page 2 ...
Page 12: ...Page 12 7 2 7 1 7 3 7 3 7 4 7 6 7 5 ...
