HOT- 565 User's Manual 12
Connectors & Sockets
Connectors & Sockets
ITEM
FUNCTION
ITEM
FUNCTION
J2, 3, 4, 5
On-board SIMM sockets
J14
Power LED and Keylock Connector
DIM1, 2
On-board 3.3V DIMM sockets
J12
PC Speaker Connector
J23, 17, 18,
19
On-board PCI Slots
JP12
Hardware Reset Switch Connector
J20, 21, 22
On-board ISA Slots
JP33
Green LED **Note 1
J6
On-board PCI Primary IDE Connector
JP15
EPMI Connector *Note 1
J7
On-board PCI Secondary IDE Connector
JP22
On-board Enhanced IDE R/W LED Connector
CN1
On-board Floppy Controller Connector
J10, 11
Universal Serial Bus (USB) Connectors *Note 2
CN4
On-board Parallel Port Connector
JP3
Infra-red Communication Port Connector *Note 3
CN2
On-board Serial port-1 Connector
JP1
Cooling Fan Connector *Note 4
CN3
On-board Serial Port-2 Connector
J99
On-board PS/2 Mouse Port Connector *Note 5
Note 1: JP33, JP15 - Green LED and EPMI connector
The main board provides an EPMI connector-JP15, this
allows the user to manually place the system into suspend
mode. This 2-pin connector connects to the case-
mounted suspend switch. If you do not have a switch for
the connector, you may use the "Turbo Switch" since it
does not have a function.
If you want to use this connector, "Power Management"
in the Power Management Setup of the BIOS section
should not be on the setting of Disabled.
JP33 is a 3-pin Green LED connector, the user can connect LED on
pin 1-2(setting 1) or pin 2-3(setting 2). Setting 1 will turn on LED on normal operation
and turn off LED on suspend mode. On the contrary, setting 2 will turn off LED on
normal operation and turn on LED on suspend mode.
Note 2: J10, J11 - USB connectors
The main board provides two sets USB (Universal Serial
Bus) connectors - J10 and J11 for USB devices use.
Note 3: JP3 - Infrared module connector
The main board provides a 5-pin infrared connector - JP3 as
an optional infrared module for wireless transmitting and
receiving.
Note 4: JP1 - 12V cooling fan power connector
