61
AC97 Modem
This item allows you to decide to enable/disable the 810 chipset
family to support AC97 Modem.
Ø
The choice: Auto or Disabled.
On board CNR Lan Selection
This item allows you to select Communication and Network to on-
board or external device.
Ø
The choice: Onboard, Ext.CNR or Auto.
IDE HDD Block Mode
Block mode is also called block transfer, multiple commands, or
multiple sector read/write. If your IDE hard drive supports block
mode (most new drives do), select Enabled for automatic detection of
the optimal number of block read/writes per sector the drive can
support.
Ø
The choice: Enabled, or Disabled
Onboard FDC Controller
This item specifics onboard floppy disk drive controller. This setting
allows you to connect your floppy disk drives to the onboard floppy
connector. Choose the "Disabled" settings if you have a separate
control card.
Ø
The choice: Enabled Disabled.
Onboard Serial Port1/Port2
Select an address and corresponding interrupt for the first and second
serial ports.
Ø
The choice: 3E8/IRQ4, 2E8/IRQ3, 3F8/IRQ4, 2F8/IRQ3,Auto, or
Disabled.
UART Mode Select
The main board support IrDA infrared through COM 2 port.
Note : FIR is not available currently.
Ø
The choice: IrDA or Normal.
TxD, RxD Polarity Active
This item specifies the Active level for RxD & TxD signal.
Ø
The choice: Hi,Lo, Lo,Hi, Lo,Lo, or Hi, Hi.
