17
Order code: 50705
ColorCue 3
You can additionally select between single chase play and multiple chase play. Press the SINGLE/MIX
button (37) to toggle between the two options.
●
Single: The LED on the button will light up in red. If this option is enabled, only one chase will be
played back at a time.
●
Mix: The LED on the button will light up in green. If this option is enabled, you can select multiple
chases to be played back simultaneously.
Slide up the fader(s) (01)–(24) of the chase(s) you want to play back. The respective LED(s) above the
fader(s) will light up and the selected chase(s) will be played back. The LED(s) on the respective
PLAYBACKS button(s) (01)–(24) are blinking during playback.
During playback you can add strobe effect. Make sure the parameter selection mode is enabled. Turn
the STROBE control (I) to add strobe effect. The adjustment range is from OFF to FULL, from low to high
frequency.
Factory Reset
Press and hold down the RECORD button (36), the DELETE button (40) and the CLEAR button (44)
simultaneously for 3 seconds to reset the LED controller to the factory settings. The LEDs on all buttons will
blink 3 times.
All programmed scenes and chases will be deleted and the fixture type will return to its default setting:
RGBWA-UV.
Summary of Contents for 50705
Page 21: ...20 Order code 50705 ColorCue 3 Dimensions...
Page 23: ...22 Order code 50705 ColorCue 3...
Page 24: ...2020 Showtec...
