31
Phantom 250 Spot
Product code: 40081
Gently lift the gobo holder a bit up and pull it out from the rotating gobo wheel, as shown in Fig. 14
and Fig. 15.
Fig. 14
Fig. 15
Very carefully remove the retainer spring from the gobo holder with a small flathead screwdriver or
similar. Please note, that high temperature silicone sealant is applied to the retainer spring.
Take the gobo out of the gobo holder. Do not touch the gobo with bare fingers.
Insert the new gobo in the gobo holder. See 6.8.3. Glass Gobo Orientation on page 32 for more
information.
Carefully insert the retainer spring with the narrow end against the gobo (see Fig. 16). To identify the
narrow end, press the spring flat: the narrow end is on the inside.
Fig. 16
Gently press the retainer spring as flat as possible against the back of the gobo using a small
flathead screwdriver or similar.
Place the gobo holder back into the gobo assembly and snap it into position.
Replace the head cover and tighten all 4 screws.
Gobo Size
Glass Gobo
Metal gobo
Fig. 17