14
Phantom 250 Spot
Product code: 40081
Installation Site Requirements
The device must be installed only indoors.
The device can be mounted to a truss or other rigging structure in any orientation.
The minimum distance between the light output and the illuminated surface must be bigger than
0,8 m.
The minimum distance to other objects must be bigger than 0,8 m.
The maximum ambient temperature t
a
= 40 °C must never be exceeded.
The relative humidity must not exceed 50 % with an ambient temperature of 40 °C.
Rigging
The device can be positioned on a flat surface or mounted to a truss or other rigging structure in any
orientation. Make sure that all loads are within the pre-determined limits of the supporting structure.
CAUTION
Restrict the access under the work area during rigging and/or derigging.
To mount the device, follow the steps below:
Fasten the 2 quick lock brackets, supplied with the device, on the mounting holes for quick lock
brackets (13). You can position the quick lock brackets in two ways, as shown in Fig. 06.
Install the clamps, as shown in Fig. 07. Make sure that you use clamps suitable for attaching the
device to a truss.
Fig. 06
Fig. 07
Attach the device to the supporting structure. Make sure that the device cannot move freely.
Secure the device with a secondary suspension, for example a safety cable. Make sure that the
secondary suspension can hold 10 times the weight of the device. If possible, the secondary
suspension should be attached to a supporting structure independent of the primary suspension. Put
the safety cable through the safety eye (14), as shown in Fig. 07.