Showa 5683, Operation Manual

Page: 20 / 68

２−７
2.4: Names and Functions of parts on Rear Panel (See Table 2-2)
Number Name Function
1
Input connector (INPUT) The bridge box or a transducer is connected.
2 Synchronization selection switch
(OSC) This switch is use to set the settings for bridge power
voltage circuit included in the amplifier.
INT: Set to be the master, using internal circuit
EXT: Set to be a slave, allowing this unit to synchronize
with the master’s bridge power voltage circuit
When the amplifier is used in a stand-alone, always set the
switch to INT. When a case is used, the synchronous
signal is supplied through in-case wiring. The amplifier unit
whose setting is set to be INT is the master; therefore,
other units should be set to EXT. For more details, see
page 3-9 Synchronization among Units.
3 Bridge power voltage selection switch
(BV) Selection of power voltage applied to the bridge can be
switched (0.5 V or 2.0 V).
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
(9)
(10)
(11)
(12)
(13)
(14)
(16)
(15)
(18)
1
2
4
6
8
3
5
7
(19)
(17)
Fig.2-1 Front panel Fig.2-2 Rear panel
Table 2-2 Rear Panel: Names and Functions(1)