2−6
2.3 Indication upon Balancing
Pressing BAL knob (4) executes bridge check and cable length compensation, thus automatically
realizing both resistance balancing and capacitance balancing. While the bridge check and cable
length compensation functions are effective (ON), the following indications appear. If there is
bridge cable disconnection or short, the problematic location is indicated repeatedly on digital
monitor (3). The indication continues until the BAL knob is pressed for five seconds or longer or
the power of amplifier is turned off. Make repair following the indication. When bridge check is not
effective (OFF), the portions enclosed by broken line are omitted, executing auto-balancing. For
how to set these functions to ON or OFF, refer to page 3-8 How to Switch Special Function
Setting.
Fig.2-5 Block diagram
for balance operation
or
Push BAL. knob.
Display bridge check
Checking AB line
Checking BC line
Checking CD line
Checking DA line
No disconnection or short
Disconnection or short
Repeatedly showing until
BAL knob being pressed
Example of Indication: When there are
disconnections at AB and DA on the bridge
Disconnection in AB on bridge
Disconnection in DA on bridge
Disconnection on wire A
No disconnection or short : Good
Repair of bridge cable or
replace sensor
Press BAL knob for five
seconds or longer
Recheck wiring
Bridge check : ON
Cable Length Compensation Check : ON
Indicating dropout rate
Cable length
Compensation check
Auto Balance
Summary of Contents for 5683
